2 - TECHNICAL INFORMATION SMART320
EN
2 - Pag. 5 / 20
Clamps (D) close again to perform remnant (C)
extraction check.
If the remnant is still inserted in the bar pusher
collet, the bar feeder stops; otherwise, it
continues its cycle.
Upper guides (H) open together with bar pusher
(A); the bar selection device (F) moves upwards
thus raising the first bar and withholding the
remaining bars. Bar (G) is dropped into the guide
channel.
Bar selection device (F) is lowered.
The first feeding carriage (M) starts its stroke.
To Next Page
Loading...
