System (SYS) Mode
SYS (System) mode is used to display information and enter settings
and adjustments into the Apollo NMS (Navigation Management
System).
SYS mode is divided into four “sub-states.” After entering SYS mode,
turning the Large knob scrolls through the sub-states. The four
sub-states are:
Navigation Info - Functions pertaining to navigation
information, such as Airspace Setup, NAV Mode Display
Programming, and Autonav time.
System Info - Functions pertaining to the Apollo NMS,
such as displaying the Software Version, and entering the
Owner’s name.
Position Sensors - Functions pertaining to the position
sensors, such as displaying Loran or GPS sensor data.
Miscellaneous Sensors - Functions pertaining to the F/ADS
(Fuel/Air Data Sensor) and the altitude encoder.
Important
When you enter SYS mode, the page displayed is the
page that was displayed the last time you were
working in SYS mode. To display the Home
(beginning) page in SYS mode, press the SYS mode
button again.
161
Operations
To Next Page
Loading...
