Editing the Flight Timer Trigger Speed
The following procedure is used to edit the flight timer trigger speed.
The flight timer may be set to start at power-up, or when the ground
speed exceeds from 10 to 500 knots. The default (factory) setting is 60
knots. The feature may also be turned off.
1.
In SYS mode, turn the Large knob to
display the Navigation Info page.
Navigation Info
Press ENT
SYS
2.
Pressing ENT activates the Navigation Info
sub-state functions. Turn the Large knob to
display the Flight Timer Trigger page.
FLIGHT TIMER
TRIGGER
AT 60 KTS
SYS
3.
Pressing SEL activates editing.
FLIGHT TIMER
TRIGGER
AT 60
KTS
SYS
4.
Turn the Small knob to display the
desired trigger speed. The trigger speed
is chosen in increments of 10 kts. OFF or
AT POWER-ON may also be chosen.
Press ENT to save the setting.
FLIGHT TIMER
TRIGGER
AT 40 KTS
SYS
195
Operations Navigation Information Sub-State
SYS
ENT
SEL
ENT
To Next Page
