Changing the Oceanic Activation Altitude
The following procedure is used to set the altitude at which the NMC
will start and stop the Oceanic/Remote Flight Phase. The default
(factory) setting is 18000 feet. Acceptable settings are from 0 to 18000
feet in 100 foot increments.
1.
In SYS mode, turn the Large knob to
display the Navigation Info page.
Navigation Info
Press ENT
SYS
2.
Press ENT to activate the Navigation Info
sub-state functions. Turn the Large knob to
display the Oceanic Altitude page.
OCEANIC ALTITUDE
16000FT
SEL TO EDIT
SYS
3.
Press SEL to activate editing.
4.
Turn the Small knob to display the
desired activation altitude. The altitude
is changed in 100 foot increments. Press
ENT to save the setting.
194
Navigation Information Sub-State Operations
SEL
ENT
ENT
To Next Page
Loading...
