DB Mode Procedures
Retrieving a Waypoint
These procedures are used to display a waypoint using the Waypoint
Retriever. Waypoints may be retrieved (displayed) by searching
according to identifier, city name, or facility name. Before retrieving a
waypoint, be sure the data card is inserted in the data card slot.
Once the waypoint is displayed—
·
If you want to navigate directly to the waypoint, press
DIRECT-TO, then NAV.
·
To display information about the waypoint, press INFO, and
turn the Small knob to view the information displays. To exit
the information function, press INFO again. The Mode
annunciator flashes while the information function is active.
· To exit without entering any changes, press any mode button
Waypoint Retrieval by Identifier
115
Operations DB Mode Procedures
To Next Page
Loading...
