Each of these values may be edited by pressing SEL, rotating the
Large and Small knobs, and pressing ENT to save any changes.
Full 300usg
Reserv 30usg
Message At 30min
SYS
The last Fuel Data Sensor display shows the current Fuel Measure
Units which are displayed for fuel information. This information may
be edited by pressing SEL, rotating the Large and Small knobs, and
pressing ENT to save the changed value. The display page is also
available in the System Info sub-state.
Fuel Measure
usg
US Gallons
SYS
Altitude Encoder Information
If the system does not include an altitude encoder, the next display is
shown for the encoding altimeter information.
Encoding
Altimeter
No Data Avail
SYS
If the encoding altimeter information is available, it will be shown as
displayed below. This screen displays the pressure altitude being sent
by the encoding altimeter, which is the current altitude without
barometric pressure adjustment.
Encoding
Altimeter
Pres Alt 1700ft
SYS
178
SYS Mode Displays Operations
To Next Page
Loading...
