Ikegami CCU-430 - System

CAMERA SETTINGS and ADJUSTMENT
5
107
UHK-430/CCU-430 1710 VER2 (E)
5.3 Menu Configuration and content
■
SYSTEM
Performs various settings for the basic operation of the camera.
Menu Item
Initial
setting
Setting value Description, Remarks
SYSTEM
SCAN MODE
Delivery
destination
Set
33
Selects the camera operational configuration. (It can be set only for self-
operation.)
H PHASE
0.0 -100 to +100
0DWFKHVWKHSKDVHRILQWHUQDOV\QFKURQL]DWLRQVLJQDOVZLWKWKHSKDVHRIH[WHUQDO
V\QFKURQL]DWLRQVLJQDOV7KHLQWHUQDOV\QFKURQL]DWLRQJRHVIRUZDUGLQ
GLUHFWLRQDQGGHOD\VZLWKGLUHFWLRQFRPSDUHGWRH[WHUQDOV\QFKURQL]DWLRQ,W
can be set only for self contain operation.)
FILTER SERVO CONT
SERVO 6(5920$18$/
6(592  6HWVWRWKHDXWRPDWLFFRQWURO
0$18$/ 6HWVWRWKHPDQXDOFRQWURO
BATT WARN VOLT
11.0V WR9 Sets the battery voltage value that issues the warning.
CAMERA ID SETUP (E)
PROGRAM NO. (E)
1 1 to 99, OFF
Sets the camera No. at the time of program operation, etc. If the display of the
camera No. is set on the OCP side, the set ID No. is displayed. If the camera No.
is set on the camera side, the set ID No. is displayed on OCP.
ID NO. (E)
11 to 40
Sets ID No. of the camera. Sets this when you want the camera No. to be detected
and displayed on the CCU side.
FIBER SINGLE MODE
CONT (E)
OFF ON, OFF
Supplies power to the camera from an external power supply DC connector with
CCU connected. So, stop the power supply from the optical cable.
If it is sets to "ON," the mode is switched to the single fiber mode.
SIMUL MODE (E)
1250$/
1250$/,1'(3
*$00$2))
Selects SIMUL MODE.
1250$/
In this mode, parameters related to color adjustment function (Color) and
outline correction function (Detail) can be individually set in 4K output and
HD output. Other controls are multi-link settings.
,1'(3*$00$
,QDGGLWLRQWR1250$/DGMXVWPHQWDERYHWKLVPRGHFDQLQGHSHQGHQWO\DGMXVW
FRQWUROVLQFOXGLQJ*$00$.1((*$,13('DQG:+,7(&/,3IRU.
and HD outputs.
OFF
4The 4K and HD outputs are controlled by common adjustment parameters.
DATE(YY/MM/DD) (E)
--- <<00'' Sets the date and time for saving files to a USB memory.
TIME (E)
--- ++0066 Sets the date and time for saving files to a USB memory.