Ikegami CCU-430 - Creating Lens Files

114
UHK-430/CCU-430 1710 VER2 (E)
5.4 Creates the Lens File
■
Creating lens files
$IWHUWKHOHQV2))¿OHLVFUHDWHGOHQV¿OHVDUHFUHDWHGIRUHDFKOHQV7KHOHQV¿OHVFUHDWHGDIWHUWKLVVWRUHGLIIHUHQWLDOGDWDIURP
WKLVOHQV2))¿OH
This section describes the setting method for serial interface supported lenses.
1 Display the ENGINEER MENU screen to select "LENS" and press the ENTER button.
2 Select "FILE SETTING" on the SUB MENU screen and press the ENTER button.
3 Select "No.1" for "NUMBER".
Select from No.1 - No.16.
Specify the number you want to set for NUMBER.
Note that assigning the same lens number overwrites
the data.
4 Select "ON" for "AUTO SEL".
6HWWKH¿OHQDPHLQ1$0(VWURZIRUHDFKOHQV
¿OH
$WWKLVWLPHWKHLQIRUPDWLRQRI1$0(QGURZDQG
"EXTENDER" are automatically acquired.
Note:
7KHUHDUHWZRGLVSOD\W\SHVIRUOHQV¿OHQDPHV
6HWWKH¿OHQDPHVRIWKH¿UVWURZ1$0(VHFWLRQWR
PDQXDOO\LQSXWIRUHDFKOHQV¿OH*LYLQJWKHOHQVW\SH
QDPHHWFPDNHVLWHDVLHUWR¿QGWKHOHQV1RDQGOHQV
compatibility.
- In the case of serial interface supported lens, the
model name automatically acquired from the lens is
GLVSOD\HGIRUWKH¿OHQDPHRIWKHVHFRQGURZ$872
6(/1$0(GLVSOD\VHFWLRQ7KLVPRGHOQDPHLV
DFTXLUHGZKHQWKHOHQV¿OHLVFUHDWHGDQGVWRUHGE\WKH
OHQV¿OHQXPEHU
5 Select "AUTO" for "FILE SET", and then select
"START".
The data acquisition starts.
1RZWKHOHQV¿OHVKDYHEHHQFUHDWHG
),/(

6(77,1*

180%(5
1$0(

(;7(1'(5
$8726(/
),/(6(7
/(167<3(
1R


2))
2))
2))
2))
),/(

6(77,1*

180%(5
1$0(
$%;$%&'
(;7(1'(5
$8726(/
),/(6(7
/(167<3(
1R$8726(/


2))
21
2))
2))
),/(

6(77,1*

180%(5
1$0(
$%;$%&'
(;7(1'(5
$8726(/
),/(6(7
/(167<3(
/(161R
386+6(7Ѝ67$57
1R$8726(/


2))
21
$872
2))