Ikegami CCU-430 - Page 92

74
UHK-430/CCU-430 1710 VER2 (E)
4.6 Auto Setup
■
Auto Black Balance
The auto black balance can be performed from the camera or the CCU front menu operation control and from the OCP or the MCP.
This section explains how to perform auto black balance from the OCP.
1 Press the ABB switch on the OCP.
7KHVWDWXVLVDXWRPDWLFDOO\FKDQJHGWRWKH&$3VWDWXVDQGWKHQWKHDXWREODFN
balance will be performed.
2 Check the results.
:KHQWKHDXWREODFNEDODQFHLVFRPSOHWH2.RU1*LVGLVSOD\HGRQWKH30
3LFWXUH0RQLWRUVFUHHQRUWKHYLHZ¿QGHUVFUHHQ
Caution:
%HVXUHWRVHWWKH5*%3('DQG0$67(53('(67$/FRQWURONQREVRQWKH2&3
to the center position before activating the auto black balance from the camera. If the
control knobs are not at the center position, the control range will be biased to one
side.
ABB
BLK SET
ABB
O K