624
9
9 Communication9.6.3 CANlink Software Conguration
2) Click Next. The following window is displayed.
●
Add
After conguring a slave station, click
Add
. The station is added to the list.
●
Delete
Select a station, click
Delete
, and then click
OK
(you can select multiple stations at a time).
●
Modify
Select a station, modify parameters, and then click
Modify
. Do not modify the station type.
●
Slave Station No.
Set the CANlink slave station number.
●
Status Code Register (D)
It is used to save the status of a slave station fed back through heartbeat frames of the slave station.
●
Start/Stop element (M)
It is an M element used to start or stop communication. When M = ON, communication is started; when M =
OFF, communication is stopped.
• In the
CANlink3.0 Cong Wizard
window, you can click
Finish
to save modications and exit, or click
X
in the
upper right corner to cancel modications and exit.
To Next Page
Loading...
