Intel 386

Index-1
#, defined, 1-3
82C59A, 9-1
A
Address bus, 6-1
Address lines
new,
3-1
Address space
configuration register,
4-6
expanded I/O, 4-3
enabling/disabling, 4-8
I/O decoding techniques, 4-6
I/O for PC/AT systems, 4-2
peripheral registers, 4-15
Addressing modes, 4-9–4-14
DOS-compatible mode, 4-9–4-10
enhanced DOS mode, 4-11, 4-13
nonDOS mode, 4-11, 4-14
nonintrusive DOS mode, 4-11, 4-12
AEN signal, deriving, B-2–B-3
AEOI mode, 9-9
aligned data transfers, 6-9
Applications, typical, 2-1
Architectural overview, 2-1–2-4
Assert, defined, 1-4
Asynchronous serial I/O unit, See Serial I/O unit
Automatic end of interrupt (AEOI) mode,
9-9
B
Baud-rate generator, 11-4–11-5, 13-5–13-6
BIU, See Bus interface unit
Block diagram
clock and power management unit,
8-2
DMA unit, 12-2
I/O port, 16-2
JTAG test-logic unit, 18-2
SIO unit, 11-2
baud-rate generator clock, 11-4
modem control signals, 11-29
receiver, 11-9
transmitter, 11-7
SSIO unit, 13-2, 13-3
baud-rate generator clock, 13-5
timer/counter unit, 10-2
watchdog timer unit, 17-2
BOUND, 18-2
Boundary scan register, 18-1
Built-in self-test, 8-12
Bulletin board system (BBS), 1-7
Bus arbiter
register addresses,
4-15, D-1
Bus arbiter, configuration, 5-3
Bus control arbitration, 12-9
Bus cycle length adjustments for overlapping
chip-select regions,
14-11, 14-12
Bus interface pins, 6-3
Bus interface unit, 3-4, 6-1–6-37
address bus, 6-1
bus control pins, 6-2
bus cycles, 6-13–6-33
BS8, 6-31–6-33
halt/shutdown, 6-26–6-27
interrupt acknowledge, 6-23–6-25
pipelined, 6-19–6-23
read, 6-13–6-14
refresh, 6-28–6-30
write, 6-16–6-18
bus lock, 6-34–6-35
LOCK# signal duration, 6-35
locked cycle activators, 6-34
locked cycle timing, 6-34
bus operation, 6-5–6-14
bus state diagram, 6-8, 6-20
bus states, 6-7–6-8
bus status
definitions,
6-5
data bus, 6-1
transfers and operand alignment, 6-9
HOLD/HLDA, 6-20, 6-35
departures from PC/AT architecture, B-4
HOLD signal latency, 6-37
timing, 6-36
INDEX