Introduction
About this user manual
11
Introduction
In this section you will find several preliminary comments on the user interface of the VISIONCONTROL control panel or the VISIONREPORT
operating software, the structure of this user manual, as well as on the symbols and text marks used.
About this user manual
On the following pages you will read how to set up the VISIONCONTROL control panel for your work environment, and how to operate it
properly with the aid of the VISIONREPORT software. iPEK took particular care during the development process to ensure that you can
operate the system safely, properly, and economically. To do this it is necessary that you read this user manual carefully before using the inspection
system. The user manual contains important instructions that help you to avoid hazards, as well as to increase the reliability and service life of
the system and the attached components. Follow all instructions with exactness so that you do not place yourself and other persons in jeopardy,
and so that you avoid damage to the system!
If you have questions on handling the VISIONCONTROL control panel that are not answered in this user manual, please contact our service
personnel.
NOTE!
Our service personnel addresses are provided starting on Seite 171.
Intended use
The VISIONCONTROL control panel has been designed exclusively for use with iPEK inspection systems and for examining pipelines of all
types. Using the control panel for purposes other than those cited above constitutes non-intended use. Never use the VISIONCONTROL control
panel for purposes other than those cited above. Never use the system at locations that contain an explosive medium! Only specially manufactured
systems have been approved for these applications; these systems are marked with the supplement
.
Catalog
The VISIONREPORT software supports various standardized catalogs depending on your locale. There are also catalogs by CDLab available
which allow data import into WinCan.
To Next Page
Loading...