iPEK VISIONCONTROL VC200 - Measured Values Display

Measuring Functions
Basic setting functions
122
Measured Values Display
REAL PIPE:
Diameter: 150.00mm
Length: 105.50mm
Rotation: 2.80°
PIPE BEND:
Radius: 51.00mm
Angle: 45.00°
Rotation: 90.00°
There are two areas of the measuring display in the relevant video view. One display shows the values of the real pipe. The other display shows the
measured values of the relevant measurement. The display of the measured values can be moved in the screen by simply dragging and dropping.
Only the display in whose setting you are currently located can be moved here.
A list of the measuring variables of the relevant measurement or the basic setting can be found in the following descriptions.
Measured values
of the relevant
measurement
3D Grid
Real Pipe