Executing the inspection
Device Control
81
Camera macro 1
Panning of pipe connections:
1. Panning to +90°
2. 360° rotation in negative direction
3. Panning to 0°
Camera macro 2
Panning to +90° and rotation by -90°
Camera macro 3
Panning to +90° and rotation by +90°
Camera macro 4
Panning to +90° and rotation by 0°
Camera macro 5
WinCan macro for diameter measurement by means of parallel laser:
Panning to -90°
Activating the camera illumination
Deactivating the camera illumination
Activating the autofocus (depending on the camera connected)
Activating the laser and 360° rotation
Deactivating the laser
Activating the camera illumination
To Next Page
Loading...