JRC JMA-5206 User Manual

3─51
3.5.15 Marking [MARK]
A maximum of 20 marks can be indicated at arbitrary positions on the radar display.
A mark created on the radar display holds the latitude and longitude.
[I] Creating Marks
Procedures 1 Press [MARK] key.
[□] will appear in the CURSOR field at the upper right of the radar display.
2 Put the cross cursor mark + on the position where a mark is to be
created, and press [ENT] key.
The cross cursor mark + will be changed into the [□] mark and fixed on the radar
display. To enter more [□] marks, repeat step 2.
Up to 20 marks can be entered.
Note: If more than 20 marks are created, the oldest mark is cleared and the newly created mark is
displayed.
[II] Clearing Marks
Procedures 1 Press [MARK] key.
The [□] mark will appear in the CURSOR field at the upper right of the radar display.
2 Put the cross cursor mark + on the mark to be cleared.
The [□] mark will disappear. To clear another [□] mark, repeat step 2.
To clear all [□] marks, press [MARK] key and then hold down [CLR] key.
* Pressing button
19
on the radar display on page 2-7 changes the cursor mode. When "□" appears, the cross
cursor is available to create "□" mark.

JRC JMA-5206 Specifications

General

Brand	JRC
Model	JMA-5206
Category	Marine Radar
Language	English