8─19
List of Alarms and other Indications
Table 8-5 List of Notification
Message Description
SET GYRO
Requires setting of true bearing.
TM RESET
Use care of resetting TM.
POSN RESET
Change the latitude and longitude sentence.
Table 8-6 List of ATA Alarms and Radar Alarms
Message Description
CPA/TCPA Closest approach point/Time for reaching the closest approach point (ATA)
GUARD ZONE A target exists in a guard zone.
LOST A target under acquisition cannot be tracked.
RADAR ALARM(IN) A target exists in a radar alarm zone.
RADAR ALARM(OUT) A target doesn't exist in a radar alarm zone.
Table 8-7 List of Operational Error Messages and Warnings
Message Description
NO HEADING DATA
ATA operation or TM selection when bearing data is invalid
NO POSITION DATA
Mark or line input when the latitude and longitude is invalid.
OUT OF RANGE
ATA out of acquisition range
CHANGE RANGE
TM selection due to TM-disabled range (96 or 120 nm)
Zooming in a ZOOM-disabled range (0.125 nm)
MAX POINT Tried to enter navigation information beyond the specified.
CAN’T TRANSMIT
Tried to transmit within 1 second after standby or when the transmitter-
receiver has any trouble.
INVALID DATA Tried to enter any data beyond its range.
MAX TARGET
The maximum number of targets of ATA is under acquisition.
SELECT STRAIGHT
The operator set PM to ON without selecting straight.
NO CARD Card not detected yet
CARD FULL Card capacity insufficient
FORMAT CARD Unformatted card
INVALID CARD Invalid card
READ FAILED Read failure
WRITE FAILED Write failure
DELETE FAILED Deletion failure
FORMAT FAILED Format failure
COPY FAILED Copy failure
NOT ALLOWED
General operation error
To Next Page
Loading...
Need help?
General
