3─104
3
3.10 APPLIED OPERATIONS
y
y y
3.10.3 Set Cursor (Cursor Setting)
This function enables the setting of detail information about cursor operation and display.
Procedures 1 Press [RADAR MENU] key twice.
Press [3] key.
Press [6] key.
The Cursor Setting Menu will appear.
Detail information about cursor operation
and display can be set by changing the
settings of the menu items.
[1] EBL/VRM Control CURS (device for cursor operation)
• This function is switched between ON and OFF of EBL/VRM Control CRUS function
• The trackball is provided as a standard device. If the trackball malfunctions, the cursor can be moved
by using the [EBL] control and [VRM] control.
• The cursor moves horizontally when [EBL] is operated, and moves vertically when [VRM] is
operated.
• To switch between EBL/VRM operation and cursor operation while ON is selected, hold down the
[EBL] control for 2 seconds.
ON: Cursor is operated using a [EBL] [VRM] control.
OFF: Cursor is operated using a trackball.
[2] Cursor Length
• Set the length of the cross cursor mark on the radar display.
SHORT : Cuts the cross cursor mark in length.
LONG : Makes the cross cursor mark twice as long as when SHORT is selected.
Cursor Setting
1. EBL/VRM Control CURS
OFF
2. Cursor Length
LONG
3.Distance Unit Simultaneity
OFF
0. EXIT
To Next Page
Loading...
