8─34
8
CODE Input
Only for “Service Egineer”
Press “0” and “ENT”
to Adjust Menu
1 2 3
4 5 6
7 8 9
+ 0 -
CLR
ENT
8.5 ADJUSTMENTS
This section describes the electrical adjustments of the equipment as the adjustment procedures to be carried
out by service persons at the time of installation.
CAUTION
Do not carry out the adjustments of the equipment
except authorized service persons. If wrong
setting is carried out, this may cause unstable
operation.
Do not carry out the adjustments during
navigation. Otherwise, the radar performance
may be affected, resulting in an accident or
trouble.
Tuning, bearing and range adjustments can be made from the
operation panel. Start the adjustment mode in the following
procedures.
How to open the Adjust Menu
Procedures 1 Continue to press [RADAR MENU] key.
The Code Input Menu will appear.
2 Press [0] key.
3 Move the cursor onto the “ENT”
button in the Code Input menu, and
press [ENT] key.
The Adjust Menu will appear.
To Next Page
Loading...
