5─45
5.3.2 Setting AIS Display Function (AIS Function)
Switch the AIS symbol display function to ON/OFF.
Procedures 1 Press [ATA MENU] key.
Press [2] key.
The AIS Setting menu will appear.
2 Press [1] key.
The AIS Function is switched between ON and
OFF.
ON: Enables the AIS display function.
OFF: Disables the AIS display function.
* Button on the radar display on page 2-7 is also available to switch the display functions.
* Note that turning OFF this function switches all AIS display functions to OFF.
When the AIS display function is set to OFF, no AIS
symbols are displayed.
The AIS display function itself is turned OFF.
Once the AIS display function is set to OFF, it is not
automatically switched to ON even if a dangerous
target exists.
Attention
AIS Setting
1. AIS Function
OFF
2. AIS Symbol Display
OFF
3. ATA Symbol Display
ON
4. CPA Limit
1 nm
5. TCPA Limit
1 min
6. AIS Filter Setting >
7. Identical Distance
100 m
0. EXIT
25
To Next Page
Loading...
Need help?
General
