5─42
5
5.3 AIS OPERATION
yy
yyy
5.3 AIS OPERATION
* Use of this function requires AIS I/F (option).
There are the following limitations on use of the AIS function,
system, and operation:
[I] This system can display a maximum of 50 AIS targets. There
are two types of filters for increasing the display priority.
(Refer to Section 5.4.6 AIS FILTER SETTING.)
[II] Keep in mind that the following restrictions are placed on use
of the AIS function:
1) The AIS function cannot be turned on in the following cases:
• MANUAL is selected for the speed sensor.
• LOG or 2-axis LOG is used for the speed sensor, and SET
and DRIFT are selected.
2) LOG or 2-axis LOG cannot be selected for the speed sensor in
the following case:
• SET or DRIFT is set while the AIS function is on.
3) MANUAL cannot be selected for the speed sensor in the
following case:
• The AIS function is on.
4) SET/DRIFT (current offset) cannot be turned on in the following
case:
• The AIS function is turned on, and LOG or 2-axis LOG is
selected for the speed sensor.
Attention
To Next Page
Loading...
