3─83
[I] Entering the own ship’s position in manual mode (Own Ship Position)
Use this function to edit the navigation information of any positions other than the own ship’s position.
Procedures 1 Press [1] key while the User Map Setting Menu is open.
The CODE INPUT Menu for entering latitude and longitude of the own ship position will
appear.
2 Enter a value as the latitude (xx° xxx.xx’) using the numeric keys [0] to
[9].
3 To switch between north latitude and south latitude, turn the [MULTI]
control.
Each time the control is turned, N (north latitude) is changed to S (south latitude), or vice
versa.
4 Press [ENT] key.
The latitude entered in manual mode will be determined.
Subsequently, enter the longitude.
5 Enter a value as the longitude (xx° xxx.xx’) using the numeric keys [0] to
[9].
6 To switch between east longitude and west longitude, turn the [MULTI]
control.
Each time the control is turned, E (east longitude) is changed to W (west longitude), or
vice versa.
7 Press [ENT] key.
The longitude entered in manual mode will be determined.
* Button on the CODE INPUT Menu is also available instead of the numeric keys.
Note: The own ship’s position manually entered by using the function above is valid only in the User
MAP Setting Menu. When control exits from the menu, the manually entered position data is
invalidated.
To Next Page
Loading...
Need help?
General
