JRC JMA-5206 - Page 210

3─141
[II] Erase Waypoint/Route (CLR WPT/Route Data)
Erase saved WPT/Route from inside the processor.
Procedures 1 Press [RADAR MENU] key twice.
The Radar Menu will appear.
2 Press [9] key.
The Plot Menu will appear.
3 Press [7] key.
The CLR MEM INIT Card Menu will appear.
4 Press [2] key.
The Waypoint/Route Erase Execution window will appear.
1. Erase
2: Cancel
[III] Initialize Card 2 (Format Card 2)
Initialize Card 2.
Procedures 1 Press [RADAR MENU] key twice.
The Radar Menu will appear.
2 Press [9] key.
The Plot Menu will appear.
3 Press [7] key.
The CLR MEM INIT Card Menu will appear.
4 Press [3] key.
The window to select whether or not Card 2 is initialized will appear.
1. Initialize
2: Cancel