5─13
Manual Acquisition [MANUAL]
Procedures 1 Move the cross cursor mark onto the target to be acquired, and press the
[ACQ] key.
The target will be acquired. The initial acquisition mark and target ID number are put to
the acquired target, and the vectors are displayed within one minute.
When using only the manual acquisition mode alone, press the [GZ ALARM] key to turn
off the automatic acquisition mode.
Use of Automatic and Manual Acquisition Modes [ACQ AUTO] / [ACQ MANUAL]
Use the manual acquisition mode while the automatic acquisition mode is on.
Manually acquire the target to which particular attention should be paid, and get the other targets automatically
acquired. If a new target appears exceeding the maximum number of targets, the manually acquired target is
displayed even in the background until it gets out of the display. However, automatically acquired targets are
canceled starting far distance from own ship.
If more targets are acquired manually in the condition
that the maximum number of targets are under
tracking, the targets under tracking will be cancelled
in the order of lower level of danger in order to track
the manually acquired targets.
Attention
Target manually captured.
The initial capture symbol is displayed.
Target that has intruded the zone for 1 min.
The capture symbol and vector are displayed.
To Next Page
Loading...
Need help?
General
