JUKI Sewing Machine - Preparation before Operation; Attaching the Needle; Threading the Needle-Thread

–
12
–
1) Turn the handwheel until the needle bar reaches
the highest point of its stroke.
2) Loosen screw
2
, and hold needle
1
with its
indented part
A
facing exactly to the right in
direction
B
.
3) Insert the needle fully into the hole in the needle
bar in the direction of the arrow until the end of
hole is reached.
4) Securely tighten screw
2
.
5) Check that long groove
C
of the needle is facing
exactly to the left in direction
D
.
4. PREPARATION BEFORE OPERATION
4-1 Attaching the needle
4-2 Threading the needle-thread
1
2
5
4
3
6
7
8
9
!0
!1
!2
!3
Note) Do not
pass this
part to
section
A
.
A
* Pass thread in
the order of
1
through
!3

as
shown in the
illustration.
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
1
2
D
B
C
A
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.