10 Configuration
148
10.5.6 CR/Ci analysis inputs (conductive/inductive conductivity)
Open: Device Menu > Configuration > Analog Inputs >
Analysis Input 1 to 4 > Configuration
Configuration point Selection/
setting option
Explanation
Designation up to 20 text characters Designation for the input
Manual compensation Yes
No
Activation of manual temperature compensation
With manual temperature compensation (setting
"yes"), the temperature value set in the configu-
ration item "Manual compensation temperature"
is used for temperature compensation. The con-
figuration item "Compensation temperature" is
grayed out.
With the "no" setting, the temperature value of
the signal selected in the configuration item
"Compensation temperature" is used and the
configuration item "Manual compensation tem-
perature" is grayed out.
Manual compensation
temperature
-25.00 up to 150 °C Temperature value for manual temperature com-
pensation (see configuration item "Manual com-
pensation")
Compensation tem-
perature
Selection from
analog selection
Analog input of the compensation thermometer
for temperature-compensated conductivity mea-
surement (see configuration item "Manual com-
pensation")
Reference temp. 15to30°C required only for conductivity measurement
with "TDS", "TC linear" or "TC curve" tem-
perature compensation:
The temperature at which the conductivity value
displayed was set
Filter Time Constant 0.0 to 25.0 s Optimization of measured value updating
The higher the value of the filter time const., the
slower the measured value is updated.
To Next Page
Loading...
