JUMO AQUIS touch P - Calibration Default Settings for Ph Sensors

13 Calibrating a pH measuring chain
212
13.2.2 Calibration default settings for pH sensors
Before you can perform a calibration, you must first enter the necessary calibra-
tion default settings. The possible settings for the pH Calibration are described
in the following.
Open the calibration default settings:
Device Menu > Calibration > Select analysis input or input of a digital sensors >
Calibration Presets
NOTE!
The "Calibration default settings" menu appears in the Device menu only if a
user with corresponding user rights is logged in. Calibration default settings of a
digital sensor only appear for linked digital sensors.
⇨ Chapter 8.2.1 "Log-on/Log-out", page 89
⇨ Chapter 8.2.7 "Digital sensors", page 95
Sample screen:
pH calibration default
settings