Juniper MX10004 - Page 172

2. Make sure that the voltage across the DC power source cable leads is 0 V.
3. Ensure that the black power supply output switch, to the right of the capve screw, is set to the
standby posion.
4. Unscrew the capve screw counterclockwise using the Phillips (+) screwdriver, number 1. (See
Figure 65 on page 162 )
Figure 65: Remove a JNP10K-PWR-DC2 Power Supply on an MX10004
5. Rotate the capve screw away from the faceplate of the power supply to release the latch.
162