Juniper MX10004 - Page 205

• Ensure that you have taken the necessary precauons to prevent electrostac discharge (ESD)
damage. See "Prevenon of Electrostac Discharge Damage" on page 263.
• Review how to handle and store the line card. See "Handle and Store MX10004 Line Cards Properly"
on page 192.
• Inspect the connector edge of the line card for physical damage. Installing a damaged line card might
damage the router.
• Ensure that the router has sucient power to power the line card while maintaining its n +1 power
redundancy. To determine whether the router has enough power available for the line card, use the
show chassis power detail command.
• Ensure that you have the following parts and tools available to install a line card in the router:
• ESD grounding strap
• Phillips (+) screwdriver, number 2
To install an MX10004 line card in the router chassis:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist and connect the other
end of the strap to one of the ESD points on the chassis. An ESD point is located above the status
LED panel on the front of the router chassis. See Figure 89 on page 195.
Figure 89: ESD Point on the Front of the MX10004
1
— ESD point
195