5. Move the wooden pallet and packing material to a staging area as close to the router as possible. Make
sure there is enough space to move the chassis from the rack to the wooden pallet.
6. Position a mechanical lift under the device. If a mechanical lift is not available, have three people support
the weight of the router while another person uses the screwdriver to remove the front-mounting
screws that attach the chassis-mounting brackets to the rack. To remove the router form the rack, see
“MX10016 Chassis Lifting Guidelines” on page 279 and “Removing an MX10016 Router From a Four-Post
Rack Using a Mechanical Lift” on page 240.
7. Remove the router from the rack (see ) and place the router on the shipping pallet. Position the router
on the pallet so that the front of the router is facing the silkscreened FRONT mark on the pallet. The
pallet also has crop marks to guide you in positioning the chassis
8. Use the 13/32-in. or 10-mm open-end or socket wrench to install the four sets of brackets and bolts
that secure the chassis to the wooden pallet.
9. Slide the plastic cover over the router chassis. The plastic cover is part of the router’s original packing
materials.
10. Place the packing foam on top of and around the router.
11. Place the power cords in the box.
12. Remove the adjustable mounting brackets from the rack and place them and their connecting screws
in the accessory box.
13. If you are returning accessories or FRUs with the router, pack them as instructed in “Packing MX10016
Components for Shipping” on page 268.
14. Verify that all accessories are present. See “Unpacking Line Cards, Routing and Control Boards, and
Switch Fabric Boards” on page 131.
15. Slide the cardboard box over the chassis, making sure that the arrows on the box point up and the
pallet fasteners to secure the cardboard box to the wooden pallet are near the bottom.
16. Attach the cardboard box to the wooden pallet by screwing two screws into each of the four pallet
fasteners. See Figure 128 on page 268.
267
To Next Page
Loading...
Need help?
General
