6-11
№
Description of procedure
Technical requirements and instructions
Clean the outer surface of the
radiator frame in the air condi-
tioning system of dirt, wash it
and blow-through.
Clean the corrugated plates of
charge-air cooler heat-
exchanger using blowing with
Perform air-blast
cleaning bleeding the
compressed air from on-
network.
drive axle breathers.
The breathers must be clean.
Remove breathers prior to
blowing, to prevent the ingress
of contamination into the hole.
It should be possible to turn
breather head by hand.
Clean the electromagnetic
compressor clutch
blowing
Perform air-blast cleaning bleeding the com-
pressed air from on-board or autonomous network.
To Next Page
Loading...