6-12
Technical requirements and instructions
Clean the conditioning con-
denser using air blowing.
Perform air-blast cleaning bleeding the com-
pressed air from on-board or autonomous network.
Grease the bolster, the saddle
support surface, the mouth, the
locking gear of bolster and the
bolster kingpin.
Grease the bolster through grease cups.
Apply an even layer of grease to the bol-
ster support plate and mouth by brushing.
(see Fig. To grease bolster).
Greases are used in accord with sugges-
tions of Appendices 2, 3.
Top up to norm the oil level in
engine crankcase.
See subsection «Oil level inspection in crankcase».
Top up to norm the electrolyte
level in storage batteries.
If necessary, clean the storage
batteries' covers of dirt and
dust.
See subsection «Storage batteries».
To Next Page
Loading...