Series 2280 Precision DC Power Supply Reference Manual Section 7: SCPI command reference
077085503 / March 2019 7-59
:OUTPut[:STATe]
This command enables or disables the source output.
Recall settings
Instrument reset
Power cycle
Usage
:OUTPut[:STATe] <state>
:OUTPut[:STATe] <state>,<channel>
:OUTPut[:STATe]?
Turn source off: OFF or 0
Turn source on: ON or 1
Disable source: DISable or 2
The channel number (default value is CH1):
 Channel 1: CH1
Channel 2: CH2
Details
Measurements cannot be made while the source is off.
Example
Switch the source output of the instrument to ON.
Also see
None
To Next Page
Loading...
Need help?
General
