Series 2280 Precision DC Power Supply Reference Manual Section 7: SCPI command reference
077085503 / March 2019 7-119
You should allow sufficient time for the command to be processed before attempting to communicate
with the instrument again.
*RST does not affect the GPIB address.
Example
:SYST:GPIB:ADDR 26
:SYST:GPIB:ADDR?
Sets the GPIB address and reads the address.
Output:
26
Also see
GPIB communication (on page 2-45)
:SYSTem:KCLick
This command allows you to enable or disable the key click sound.
Recall settings
Instrument reset
Power cycle
Usage
:SYSTem:KCLick <state>
:SYSTem:KCLick?
Disable the key click sound: OFF or 0
Enable the key click sound: ON or 1
Details
This command enables or disables the key click sound. When enabled, any key presses on the front-
panel will output a sound signaling that a front-panel key has been pressed.
Example
Also see
None