Keithley 2280S-32-6 - Cls

Section 7: SCPI command reference Series 2280 Precision DC Power Supply Reference Manual
7-2 077085503 / March 2019
Although the commands in this section are shown in uppercase, common commands are not case
sensitive (you can use either uppercase or lowercase).
*CLS
This command clears the event registers and error queues.
Type
Affected by
Where saved
Default value
Command only
Not applicable
Not applicable
Not applicable
Usage
*CLS
Details
Use *CLS to clear the event registers and queues. It performs the following actions:
 Clear the Standard Event Status Register and Status Byte Register.
 Clear the event register of Questionable Event, Questionable Instrument Event, and Questionable
Instrument Summary Event.
 Clear the event register of Operation Event, Operation Instrument Event, and Operation Instrument
Summary Event.
 Clear the event register of Measurement Event, Measurement Instrument Event, and Measurement
Instrument Summary Event.
 Clear the error queue.
To reset all of the bits of the Standard Event Enable Register, send the command:
*ESE 0
Also see
*ESE (on page 7-3)
STATus subsystem (on page 7-94)