To Next Page

To Previous Page

Series 2280 Precision DC Power Supply Reference Manual Section 7: SCPI command reference

077085503 / March 2019 7-61

:SENSe[n]:<function>:AVERage:COUNt

This command sets the number of measurements that are averaged when filtering is enabled for the specified

function.

Type

Affected by

Where saved

Default value

Command and query

Recall settings

Instrument reset

Power cycle

Save settings

Usage

:SENSe[n]:<function>:AVERage:COUNt <value>

:SENSe[n]:<function>:AVERage:COUNt?

:SENSe[n]:<function>:AVERage:COUNt? DEFault

:SENSe[n]:<function>:AVERage:COUNt? MINimum

:SENSe[n]:<function>:AVERage:COUNt? MAXimum

[n]

Channel number: For single-channel instruments, the value is 1

The measurement function to which this setting applies:

 Concurrent: CONCurrent[:DC]

 Current: CURRent[:DC]

 Voltage: VOLTage[:DC]

<value>

The number of readings required for each filtered measurement (2 to

100)

Details

The filter count is the number of readings that are acquired and stored in the filter stack for the

averaging calculation. When the filter count is larger, more filtering is done and the data is less noisy.

Example

SENS:CONC:AVER:WIND 0.1

Set the average filter window as 0.1%.

Also see

:SENSe[n]:<function>:AVERage[:STATe] (on page 7-62)

:SENSe[n]:<function>:AVERage:TCONtrol (on page 7-63)

:SENSe[n]:<function>:AVERage:WINDow (on page 7-64)

Keithley 2280S-32-6 Reference Manual

Other manuals for Keithley 2280S-32-6