Keithley 6517B

Model 6517B Electrometer Reference Manual Section 14: SCPI command reference
6517B-901-01 Rev. C / August 2015 14-33
:FORMat <name>
This command is used to specify the CALC 1 format.
Usage
:CALCulate[1]:FORMat <name>
:FORMat?
<name>
 NONE: No calculation
 PERCent: Percent calculation
 POLynomial: Polynomial calculation
 RATio: Ratio calculation
 DEViation: Deviation calculation
 PDEViation: Percent deviation calculation
 LOG10: Logarithmic base 10 calculation
Details
This command is used to specify the format for the CALC 1 math calculation. With NONE selected, no
CALC 1 calculation is performed. With one of the other formats selected and CALC 1 enabled, the
result of the calculation is displayed. The calculated reading is refreshed every time the instrument
takes a reading.
Also see
:STATe <b> (on page 14-35)
KMATh commands
:MA0Factor <NRf>
This command is used to specify the "a0" factor.
Usage
:CALCulate[1]:KMATh:MA0Factor <NRf>
:MA0Factor?
<NRf>
 -9.999999e30 to +9.999999e30
Details
This command is used to define the "a0" factor for the polynomial calculation.
Also see
None