To Next Page

To Previous Page

Model 6517B Electrometer Reference Manual Section 14: SCPI command reference

6517B-901-01 Rev. C / August 2015 14-35

:REFerence <NRf>

This command is used to set the reference value for ratio, deviation, and percent deviation

Usage

:CALCulate[1]:REFerence <NRf>

:REFerence?

<NRf>

 -9.999999e35 to +9.999999e35: Specify reference value

Details

This command is used to specify the reference value for the ratio, deviation, and percent deviation

calculation.

Also see

None

:STATe <b>

This command is used to control the CALC 1 calculation.

Usage

:CALCulate[1]:STATe <b>

:STATe?

<b>

 0 or OFF: Disable CALC 1 calculation

 1 or ON: Enable CALC 1 calculation

Details

This command is used to enable or disable the CALC 1 calculation. When enabled, each instrument

reading reflects the selected calculation.

Also see

:FORMat <name> (on page 14-37)

DATA commands

[:LATest]?

This command is used to read the CALCulate[1] result.

Usage

:CALCulate[1]:DATA[:LATest]?

Details

This query command is used to read the result of the CALCulate[1] calculation. If CALCulate[1]

is disabled or NONE is selected, the "raw" reading is read instead.

Also see

CALCulate[1] (on page 14-32)

Keithley 6517B Reference Manual

Other manuals for Keithley 6517B