Keithley 6517B Reference Manual

Model 6517B Electrometer Reference Manual Section 14: SCPI command reference
6517B-901-01 Rev. C / August 2015 14-153
:ASYNchronous commands
:ILINe <NRf>
This command is used to select the input trigger line arm, scan, and measure layers.
Usage
:ARM[:SEQuence[1]][:LAYer[1]]:TCONfigure:ASYNchronous:ILINe <NRf>
:ARM[:SEQuence[1]]:LAYer2:TCONfigure:ASYNchronous:ILINe <NRf>
:TRIGger[:SEQuence[1]]:TCONfigure:ASYNchronous:ILINe <NRf>
:ILINe?
<NRf>
 1: Line #1
 2: Line #2
 3: Line #3
 4: Line #4
 5: Line #5
 6: Line #6
Details
These commands are used to select an input line for the asynchronous trigger link of the specified layer. Keep in
mind that asynchronous trigger link input and output cannot share the same line. If you assign the input to a line
that is already being used for the output, an error occurs and the command is ignored.
Also see
:OLINe <NRf> (on page 14-153)
:OLINe <NRf>
This command is used to select the output trigger line arm, scan, and measure layers.
Usage
:ARM[:SEQuence[1]][:LAYer[1]]:TCONfigure:ASYNchronous:OLINe <NRf>
:ARM[:SEQuence[1]]:LAYer2:TCONfigure:ASYNchronous:OLINe <NRf>
:TRIGger[:SEQuence[1]]:TCONfigure:ASYNchronous:OLINe <NRf>
:OLINe?
<NRf>
 1: Line #1
 2: Line #2
 3: Line #3
 4: Line #4
 5: Line #5
 6: Line #6
Details
These commands are used to select an output line for the asynchronous trigger link of the specified
layer. Keep in mind that asynchronous trigger link input and output cannot share the same line. If you
assign the output to a line that is already being used for the input, an error occurs and the command
is ignored.
Also see
None

Keithley 6517B Specifications

General

Input Impedance	>200 TΩ
Electrometer Type	Electrometer/High Resistance Meter
Current Measurement Range	20 fA to 20 mA
Display	Vacuum Fluorescent Display
Communication Interfaces	IEEE-488 (GPIB), RS-232
Power Supply	100 V / 120 V / 220 V / 240 V; 50 Hz / 60 Hz
Resistance Measurement Range	Up to 200 TΩ