Keithley 6517B Reference Manual

Model 6517B Electrometer Reference Manual Section 14: SCPI command reference
6517B-901-01 Rev. C / August 2015 14-161
:MDELay <NRf>
This configuration command is used to specify the measure time for the specified test.
Usage
:TSEQuence:DLEakage:MDELay <NRf>
:TSEQuence:RVCoefficient:MDELay[1] <NRf>
:TSEQuence:RVCoefficient:MDELay2 <NRf>
:MDELay?
<NRf>
0 to 99999.9 Measure delay in seconds (resistor voltage coefficient test)
0 to 10000 Delay in seconds (diode leakage test)
Details
This command is used to specify the measure time for the specified test. Note that the resistor
voltage coefficient test uses two measure delays; delay 1 and delay 2.
This configuration command is used for the following tests:
 Diode leakage test
 Resistor voltage coefficient test
:TSEQuence:DLEakage:MDELay <NRf> specifies the measure delay for a diode leakage test.
:TSEQuence:RVCoefficient:MDELay[1] <NRf> specifies measure delay 1 for the resistor
voltage coefficient test.
:TSEQuence:RVCoefficient:MDELay2 <NRf> specifies measure delay 2 for the resistor voltage
coefficient test.
:MDELay? queries the measure delay.
Also see
None

Keithley 6517B Specifications

General

Input Impedance	>200 TΩ
Electrometer Type	Electrometer/High Resistance Meter
Current Measurement Range	20 fA to 20 mA
Display	Vacuum Fluorescent Display
Communication Interfaces	IEEE-488 (GPIB), RS-232
Power Supply	100 V / 120 V / 220 V / 240 V; 50 Hz / 60 Hz
Resistance Measurement Range	Up to 200 TΩ