Model 6517B Electrometer Reference Manual Section 2: Getting started
6517B-901-01 Rev. C / August 2015 2-27
GENERAL
The GENERAL menu is used for the following operations:
To control the state and sense of the digital outputs.
To view the serial number, SCPI version, and firmware revision levels of the Model 6517B.
To set line synchronization of readings, display the frequency of the line power, and configure the
A/D to measure humidity and external temperature.
To configure time stamp.
To choose the character displayed for a decimal and select measurement units.
To set the real-time clock.
DIGOUT (Digital I/O menu)
DIGOUT controls the Digital I/O port. See Digital I/O (on page 10-6) for complete information.
SERIAL #
This item displays the serial number, SCPI version, and firmware revision levels of the instrument.
The following information is displayed:
Serial #XXXXXX
SCPI version 1996.0 software rev AXX AYY
Where:
#XXXXXX is the serial number of the instrument
AXX is the firmware level for the main microcontroller
AYY is the firmware level for the display microcontroller
To Next Page
Loading...
