Keithley 6517B Reference Manual

Section 14: SCPI command reference Model 6517B Electrometer Reference Manual
14-148 6517B-901-01 Rev. C / August 2015
:DELay <n>
This command is used to set the scan and measure layer delays.
Usage
:ARM[:SEQuence[1]]:LAYer2:DELay <n>
:TRIGger[:SEQuence[1]]:DELay <n>
:DELay?
:DELay? DEFault
:DELay? MINimum
:DELay? MAXimum
<n>
 0 to 999999.999: Specify delay in seconds
 DEFault: 0 second delay
 MINimum: 0 second delay
 MAXimum: 999999.999 second delay
Details
These delay periods are used to delay operation in the specified layer. After the programmed event
occurs, the instrument waits until the delay period expires before proceeding on in the trigger model
(see the IEEE-488 trigger model (on page 11-16)). Note that the arm layer (Arm Layer 1) does not
use a delay.
Also see
None

Keithley 6517B Specifications

General

Input Impedance	>200 TΩ
Electrometer Type	Electrometer/High Resistance Meter
Current Measurement Range	20 fA to 20 mA
Display	Vacuum Fluorescent Display
Communication Interfaces	IEEE-488 (GPIB), RS-232
Power Supply	100 V / 120 V / 220 V / 240 V; 50 Hz / 60 Hz
Resistance Measurement Range	Up to 200 TΩ