04 Singing | 45
• ON/OFF: enables or disables microphone input (corresponds to pressing the
MICRO button on the panel).
• Preset: touch this part of the screen to select a preset microphone setting from
STANDARD, MELLOW, SMALL, LARGE, GATED, LIVE, ECHO ONLY, SPECIAL EFX1,
SPECIAL EFX2, DOUBLE VOICE and User Preset 1 to 10. Each preset has different
parameters of volume, reverb, echo, effects and equalizer parameters. Press the
UP/DOWN buttons to scroll through the available ones, or touch name to load a
preset.
• Vol.: adjust the output volume by pressing the UP/DOWN buttons. The value
ranges from 0 to 127.
• Reverb: this effect, like the three that follow at the bottom of the screen, has a
checkmark that can be tapped to enable or disable the effect. Touch the Reverb
icon to select one of the available options: ROOM 1, ROOM 2, ROOM 3, HALL 1,
HALL 2, HALL 3, PLATE 1 and PLATE 2. Press the Edit button on the screen to open
the reverb customization page.
• REV: Adjusts the amount of delivery of the selected reverb.
• Equalizer: this is a four-band parametric equalizer: see below the paragraph
dedicated to the EQ of the microphone.
• Echo Type: it is a replica of a signal after a certain amount of time. Select a delay
value from Mono, Stereo, Triplet, Multitap, Reflection, Stage, PingPong, and
EchoTap.
• Compression: reduces dynamic range. Select a compression preset between
Compr -15dB, Compr -18dB, Compr -21 dB, Compr -24dB, Limiter -6dB, and
Limiter -18 dB. Each preset has a different threshold and ratio values (limiters have
an infinity ratio value).
• Pitch Shift: increases or decreases the intonation of the voice, drastically changing
the sound of the voice. Select a preset from Male, Female, Robot, Duck, Bear,
Mouse, Dark, Cartoon, Double Choir.
• Talk: This mutes (turns off) the effects on the signal in order to use the
microphone to speak and not to sing.
• Talk Mode: to use when Talk is enabled. In general, it acts on the reverberation
by reducing its length to increase speech comprehension in the room. Possible
values: No EFX , Short1 and Short2.
• NOISE GATE: to set the volume threshold beyond which the audio signal should
not exceed (-64 dB, -56 dB, -48 dB, -40 dB, -32 dB, -24dB). The value OFF stands
for NOISE GATE inactive.
• INPUT: it could also be used for a microphone. In the frame at the bottom right of
the screen, you can activate it ON/OFF, adjust the volume and the reverb send.
At the bottom of the screen, the FACTORY RESTORE and FACTORY OVERWRITE buttons
allow you to restore the factory parameters or replace them with the current values,
respectively.
To Next Page
Loading...
