1st Menu Level 2nd Level 3rd & 4th Levels Description
Pace Specifies Dwell or Trigger paced list
Repeat Specifies number of list repetitions, or continuous list
Terminate Specifies list termination conditions
Config Configures individual list step settings
Reset Aborts the list and resets all list settings
Arb Displays Arb commands
Repeat Specifies number of Arb repetitions, or continuous Arb
Terminate Specifies Arb termination conditions
Config Configures individual Arb settings
TrigSource Specifies the transient and CD Arb trigger source
Control Initiates, triggers, and aborts transients; displays trig state
Protect OVP Configures over-voltage protection settings
OCP Configures over-current protection settings
Inhibit Configures inhibit input mode settings
WDog Configures output watchdog protections settings
SFD Enables/disables sense fault detection
Mode Specifies turn-off behavior for all protection conditions
Clear Clears protection conditions and displays output status
States Reset Resets all instrument settings to the reset(*RST) state
SaveRecall Saves and recalls instrument settings
PowerOn Selects the power-on instrument state
System IO Displays IO commands
LAN Displays LANcommands
Settings View the currently active network settings
Modify Modify the network configuration
(IP, Name, DNS, WINS, mDNS, Services)
Apply Applies the configuration changes and restarts unit
Cancel Cancels the configuration changes
Reset Performs an LXI LCI resetof LANsettings and restarts
Keysight N6900/N7900 Series Operating and Service Guide 23
1 Quick Reference
To Next Page
Loading...
Need help?
General
