How to fix Condition Code 10001 on Kodak Printer?
To resolve Condition Code 10001 on the Kodak Printer: 1. Shut down the imager, then start the imager. 2. If the error persists, call for service.
Why is my Kodak Dryview 5800 offline?
The Kodak Printer is offline because it has been disabled and does not have a network connection.
How to fix Condition Code 21145 or 23145 on Kodak Dryview 5800?
To address Condition Code 21145 or 23145 on your Kodak Printer: 1. The imager has not been configured to use this film type. 2. Try a different film type or reconfigure the imager. 3. If the error persists, call for service.
What to do if Kodak Dryview 5800 says 'Film Covered'?
The Kodak Printer indicates 'Film Covered' because either the film bag or film saver is still on and must be removed before the film tray can be used.
What does 'Unlock Pending' mean on Kodak Dryview 5800 Printer?
The Kodak Printer displays 'Unlock Pending' because an “Unlock” has been requested but has not started because films are still moving through the imager.
How to fix Condition Code 06400 on Kodak Printer?
To resolve Condition Code 06400 on the Kodak Printer: 1. Delete jobs in the 'Unprintable jobs' queue. 2. Resend the print job from the image source. 3. If the error persists, call for service.
How to fix Condition Code 04200 on Kodak Dryview 5800?
To resolve Condition Code 04200 on the Kodak Printer: 1. Delete jobs in the 'Unprintable jobs' queue. 2. Load requested film type for jobs in the 'Waiting for media' queue. 3. If the error persists, call for service.
What does 'Any Film Supply Open' mean on Kodak Printer?
The Kodak Printer shows 'Any Film Supply Open' because at least one of the film trays is not inserted and latched into place.
What to do if my Kodak Dryview 5800 Printer says 'Door Open'?
The Kodak Printer displays 'Door Open' because the imager hood is open or one of the side panels may be off.
What does 'Unprintable jobs queued' mean on my Kodak Printer?
The Kodak Printer has queued jobs that can never be printed and should be deleted by the user.
Details key preventive measures and electrostatic discharge (ESD) precautions.
Lists required items and materials for initial imager setup.
Guides connection of laptop, energizing, de-energizing, and logging into the service tool.
Covers language, DICOM, system clock, network, service tracking, film loading, and SCP.
Covers processor drum temperature and imaging AY alignment procedures.
Details procedures for replacing panels, processor, drums, motors, and sensors.
Lists necessary materials, tools, and defines PM intervals and EM call checklists.
Outlines steps for performing PM, including cleaning, parts replacement, and resets.
Explains service switch, local panel LEDs, buttons, icons, and status messages.
Details subsystem IDs, severity levels, and lists condition codes with descriptions.
Illustrates and lists parts for the main imager assembly and film feed system.
Details parts for pickup assemblies, processor frame, cover, and electronics bracket.
Lists parts for electronics bracket, front cover, and accessory kits.
Instructions for backing up and restoring system configuration parameters.
Procedures for updating thumb drives, hard drives, and microcontroller firmware.
General| Print Technology | Dry Laser Imaging |
|---|---|
| Grayscale Resolution | 12 bits |
| Media/Film Size | 14 x 17 inches |
| Connectivity | Ethernet |
| Power Requirements | 100-240 VAC, 50/60 Hz |
To Next Page
