2.3 Prohibited use
Other use than described in chapter 2.2 is not intended and can lead to damage of per
-
sons, equipment or things.
The use of the servo amplifier in the following environments is prohibited:
- potentially explosive areas
- environments with corrosive and/or electrically conductive acids, alkaline solutions,
oils, vapors, dusts
- directly on non-grounded supply networks or on asymmetrically grounded supplies
with a voltage >230V.
- on ships or off-shore applications
Commissioning the servo amplifier is prohibited if the machine in which it was installed,
- does not meet the requirements of the EC Machinery Directive
- does not comply with the EMC Directive or with the Low Voltage Directive
- does not comply with any national directives
The control of holding brakes by the S300 alone may not be used in applications, where
functional safety is to be ensured with the brake.
2.4 Warning notes placed on the product
Residual Voltage.
Wait 5 min. after
removing power.
If these signs are damaged, they must be replaced immediately.
S300 Instructions Manual 13
Kollmorgen 02/2017 Safety
To Next Page
Loading...
Need help?
General
