3.7 Repair
Only professional staff who are qualified in electrical engineering are allowed to exchange
parts of the drive system.
CAUTION: Automatic Start! During replacement work a combination of hazards and
multiple episodes may occur.
- Work on the electrical installation may only be performed by trained and qualified
personnel, in compliance with the regulations for safety at work, and only with
use of prescribed personal safety equipment.
Exchange of servo amplifier
Only the manufacturer can repair the device. Opening the device voids the warranty.
1. Decommission the device (see chapter 3.4).
2. Demount the device (see chapter 3.6).
3. Contact Kollmorgen and clarify the logistics. Send the device to the address given by
Kollmorgen.
4. Install a new device as described in this manual.
5. Setup the servo amplifier as described in this manual.
Exchange of other drive system parts
If parts of the drive system ( for example cables) must be replaced, proceed as follows:
1. Decommission the device (see chapter 3.4).
2. Exchange the parts.
3. Check all connections for correct fastening.
4. Setup the servo amplifier as described in this manual.
3.8 Disposal
To dispose the unit properly, contact a certified electronic scrap disposal merchant.
In accordance with the WEEE-2002/96/EC-Guidelines and similar, the manufacturer
accepts returns of old devices and accessories for professional disposal. Transport costs
are the responsibility of the sender.
Decommission the device as described in chapter 3.4 and demount the device as
described in chapter 3.6.
Contact Kollmorgen and clarify the logistics. Send the device to the address given by
Kollmorgen.
16 S300 Instructions Manual
Handling 02/2017 Kollmorgen
To Next Page
Loading...
Need help?
General
