Ch.6 Troubleshooting
< 153 >
REGIUS Console CS-3 OPERATION MANUAL Ver. 1.10 2005.2
7 Touch the [YES] button to re-boot all REGIUS
MODEL 170/190 units.
• Photography using REGIUS MODEL 170/190 will
again be possible after completion of switchover
to the backup JM
After completion of switchover to the backup JM, the message shown below will be
displayed on other CS-3 units connected to the same system.
Touch the [YES] button to close the message window.
Photography using REGIUS MODEL 170/190 will now be possible.
After completing switchover of functions to the backup JM, the nearest service cen-
ter should be contacted as soon as possible.
7
To Next Page
Loading...
Need help?
General
