Ch.3 Sequence of Examination
< 66 >
REGIUS Console CS-3 OPERATION MANUAL Ver. 1.10 2005.2
Allocating the Annotations
Procedures to allocate the annotations are described below.
Mouse and keyboard may be necessary to operate some of annotation functions.
Maximum 10 annotations can be allocated.
Maximum number of characters that can be used for annotation is 128 (full size) or
256 (half size) characters.
Relation between Annotation and Rotation/Flip
How it is look like when the image is rotated or flipped after the annotation has been
allocated. The upper left corner of text box for the annotation is interlocked with the
image, but the text itself will not rotate or flip.
• Rotation
• Flip
90º Rotate
Flip
Annotation font size and output method (1 to 1/ whole image output)
When the whole image is output after allocating the annotation, the annotation fonts
are reduced in proportion to the image so that the whole image fits to the output
size. This results in output of annotation font size not identical to the “Font Size” set
in the “Annotation” screen.
When a large image, especially a long body part is output to a smaller film by setting
to “Whole Image” output, it may be necessary to set the annotation with a little larger
font. Also to be noted is that even the output is made under the same font size and
output method, output font size may be slightly different depending on the resolu-
tion (Normal/High Res).
To Next Page
Loading...
Need help?
General
