Ch.3 Sequence of Examination
< 61 >
REGIUS Console CS-3 OPERATION MANUAL Ver. 1.10 2005.2
The procedures to reference and output the image after finishing examination are described below.
Image Reference after Examination (Output Again)
1 Touch the [KONICAMINOLTA] button on the initial
screen.
• The system menu is displayed.
3 Touch the patient data in which the image to be
referenced or output again is contained.
• The patient data in suspend status is displayed in
purple color.
• The frame color around the patient data that is
selected will turn to green.
2 Click the [History] button.
• The examination history screen is displayed.
4 Touch the [Edit] button.
• The image reference screen is displayed.
5 Touch the order to be referenced.
• The image corresponding to the selected order is
displayed in the image display field.
6 Touch the [Output] button to output the image.
• The output setting screen is displayed.
Only suspended exami-
nation information for
which image output has
been completed may
be re-output.
Data for which expo-
sure has been complet-
ed but for which image
output has not will be
displayed, but may not
be re-output.
Because the image
has not been verified
as OK, the [Output]
button is not active.
7 Click the [Output Destination] button to select
the output device.
8 Touch the [OK] button.
• The image data is output to the selected output
device.
• The output setting screen is closed.
Follow the steps below to cancel the queue that has not been output.
1. Ensure that there is
the queue that has
not been output in
the printer status
check screen or host
status check screen.
2. Invoke the output set-
ting screen.
• Ensure that the [Output
Destination] button for
the queue that has not
been output is kept
selected.
3. Touch the selected
[Output Destination]
button to cancel the
queue.
p.134 Host Status
Check
Screen
p.135 Printer
Status
Check
Screen
Multiple devices can be
selected at a time as
the output device.
2
4
3
6
7
8
1
2
3
To Next Page
Loading...
Need help?
General
