Konica Minolta CS-3 User Manual

Ch.6 Troubleshooting
< 157 >
REGIUS Console CS-3 OPERATION MANUAL Ver. 1.10 2005.2
The same error occurs repeatedly.
Error No.
10000
11000
12000
12001
12002
12003
12010
12011
12012
12020
12200
12201
12202
12203
12204
12205
12206
12207
12208
12209
12210
12211
12212
12220
13000
13001
13030
13031
14000
14001
14002
14003
14010
14011
22101
22103
22104
23000
23200
23900
24000
25000
25100
25200
25210
25300
26000
Error Message Remedy
Concerning the Cassette Readers
Memory Error
Hardware Error
Msg Receiving Timeout (High Voltage ON)
Msg Receiving Timeout (Laser ON)
Msg Receiving Timeout (Mech. Ready)
Msg Receiving Timeout (Mech. Standby)
Serial communication Error (Mech. Resend Overflow)
Serial communication Error (Mech. CRC error Overflow)
Serial communication Error (Mech. Overrun)
Msg Error (Mech. illegal Msg)
Msg Receiving Timeout (Net Initialize)
Msg Receiving Timeout (Net Ready)
Msg Receiving Timeout (Put Shading)
Msg Receiving Timeout (Status Check)
Msg Receiving Timeout (Barcode Seek)
Msg Receiving Timeout (Net Command)
Msg Receiving Timeout (Reader End)
Msg Receiving Timeout (Put Qrv)
Msg Receiving Timeout (Put Config)
Msg Receiving Timeout (Put Information)
Serial communication Error (Net Resend Overflow)
Serial communication Error (Net CRC error Overflow)
Serial communication Error (Net Overrun)
Msg Error (Net illegal Msg)
Optical Unit Error (H_Sync)
Optical Unit Error (Polygon ID)
SCB Control Error (DMA transfer)
SCB Control Error (SCOM communication)
Signal Proc Error (Gain Overflow)
Signal Proc Error (Gain Underflow)
Signal Proc Error (Offset Overflow)
Signal Proc Error (Offset Underflow)
Signal Proc Error (QRV Overflow)
Signal Proc Error (QRV Underflow)
Serial Communication Error (N1 Counter Over)
Serial Communication Error (N3 Counter Over)
Serial Communication Error (N4 Counter Over)
Program Error (Main Control)
Program Error (Data File Size)
Program Error (Firmware Update)
Network Error (JM Connection)
Network Error (Non-Timeout)
Network Error (Timeout:in General Communication)
Network Error (Timeout:in Image Transmission)
Network Error (Timeout:after Image Scanning)
Network Error (Timeout:Image Re-Transfer State)
Operation Error (Invalid Job)
Restart the CS-3 and REGIUS MODEL
170/190.
Contact your Service Representative.
Restart the REGIUS MODEL 170/190.
Restart the CS-3 and REGIUS MODEL
170/190.
Contact your Service Representative.
The same error occurs repeatedly.
The same error occurs repeatedly.
The same error occurs repeatedly.

Konica Minolta CS-3 Specifications

General

Brand	Konica Minolta
Model	CS-3
Category	Medical Equipment
Language	English